La-Man
La-Man
  HomeProductsAuto DivisionFAQ'SContact UsSite Map

Products

Search


 


Made In USA

Drains and Valves

WEEP DRAIN CYCLE DRAIN
WEEP DRAIN CYCLE DRAIN

Weep Drain - Standard
The La-Man WEEP DRAIN or petcock, model #10535, is the standard drain supplied on all our Extractor/Dryer models. This drain is designed to constantly weep a very small amount of air, .16 to .2 CFM at 100 PSI. The drain should always be open in order to allow the extracted moisture to depart the base of the Extractor/Dryer® unit. If noise or air loss are concerns, please see our patented automatic Float Drain, which is specifically designed for the Extractor/Dryer.

Cycle Drain
The CYCLE DRAIN, model #520CD, is used with the Model #520A & 520B only. This drain will model #500fdautomatically expel liquids from the Extractor/Dryer. Requires intermittent air flow for operation. There is no air loss.

Float Drain
Our patented automatic FLOAT DRAIN, model #500FD, was especially designed to fit all models of the Extractor/Dryer (except the 195A). The external bowl is used to collect liquids and contaminants removed by the Extractor/Dryer. Operation is dependent on the liquid level inside the drain bowl and is dispensed by a float controlled device. Prevents any air lose and noise. A clear drain hose is provided.

Electronic Drains
The La-Man® line of ELECTRONIC DRAINS can be added to any Extractor/Dryer, compressor or surge tank, and drip legs. Adjustable intervals and discharge times available in various models. These drains work especially well with applications that have excessive amounts of water, which require controlled monitoring and must be matched to the drainage requirements.

Specification
MODEL No.
SED511-01
 
SED522-02
SED522-03
SED522-04
NPT
1/8"
1/4"
3/8"
1/2"
Interval Time
0 - 30 Minutes
0 - 45 Minutes
Discharge Time
2 Seconds, Fixed
.05 - 10 Seconds
Supply Voltage
110 VAC, 50/60 HZ
110 VAC, 50/60 HZ
Max. Working Pressure
300 PSIG
300 PSIG
sed522
sed511
 
Relieves downstream pressure and accepts locking devices when used before servicing the air filter.
  • 300 psi maximum working pressure
  • Available in sizes from ¼" NPT to 2" NPT
  • Satisfies OSHA requirements